First 10 words: T-H Marine Supplies T-H Marine MJ-1-DP Mini Jacker
Last updated on July 25, 2024 8:26 am Details
First 10 words: T-H Marine Supplies T-H Marine MJ-1-DP Mini Jacker
Original price was: $253.99.$130.40Current price is: $130.40.
Description
- Clamp style small outboard jack plate
- Super for skiffs, aluminum boats, and inflatables
- 4″ setback, 3″ vertical offset, Max Weight: 150 lbs., Max Horsepower: 35 HP
- Cast aluminum bracket
- Marine grade transom block
Additional information
Specification: First 10 words: T-H Marine Supplies T-H Marine MJ-1-DP Mini Jacker
|
price Statistics
Reviews (8)
8 reviews for First 10 words: T-H Marine Supplies T-H Marine MJ-1-DP Mini Jacker
Show all
Most Helpful
Highest Rating
Lowest Rating
Daniel R. Henninger –
Allows me to properly run my 6hp long shaft kicker for my big boat on my 12ft aluminum boat. Seems like a solid product so far. Time will be a real test, as far as durability.
Morris Capers –
Bought this to lift a long shaft motor on a short transom aluminum boat. It is very sturdy and well designed. Think and measure before you drill and it is easy to install. We mounted it high and got about six inched of lift. The 14ft aluminum boat does about 20 mph now with a 9.9 Mercury four…
Timothy –
This thing is Awesome. My 12’ sea nymph now has a 20 hp long shaft 4 stoke motor on it. The motor weighs i at just 100 lbs. I did push my mount up another 3 inches past the transom top. Two bolts on each side. Now I have a 12’ tin rocket. It’s scary fast. Mount Holds fine! Get one. Simple as that.
CYPRESS –
Works great for a 1436 Jon Boat. You can raise or lower and adjust it by uninstalling it and re-bolting it. After installing, I realized that I could go up one more inch. Just drill out the marked holes on the mini-jacker and re-bolt to transom. The wood has no water protection so a couple of…
Morris Capers –
The build quality is good. I have yet to drill any holes into the boat or the jack plate itself. I am satisfied with my purchase. Cannot wait to install this permanently to the boat.
Miquel –
Built really well,bolted on easily but the 3″ lift was to much for me. After playing with some spacers I only needed 3/4″ to 1″ of lift and if you go lower than the 3″ lift you can’t get to the motor mounts.
Daniel R. Henninger –
Wow! This is the one thing you must have! Even though the transom on most aluminums is 15” the actual distance from clamp to ride plate is 18”. This bad boy fixes that problem fast, quick and in a hurry!
It took me all of 20 minutes to install and that includes finding the 25/64 drill bit for the…
troy lynch –
A quality made product, the wood was cut to fit perfectly needs a few coats of linseed oil. mounting was easy got it clamped in place drilled the pre marked spots installed with stainless bolts. I would suggest using large fender washers on the inside of the transom and use a good sealant in the…